Testing Apparatus

Product Details:

We are engaged in offering a wide range ofLeak Test Apparatus   to our clients. Our range of all products is widely appreciated by our clients

Product Details:

We are engaged in offering a wide range of   Foaming Test Apparatus to our clients. Our range of all products is widely appreciated by our clients

Product Details:

Test Method: - Flash Point is lowest temperature at which application of the ignition source causes the Vapour of a specimen of the sample to ignite under the specified condition of the test.The temperature of the approximately 70 ml test specimen is increased rapidly at first and then at a slower constant rate as the flash point is approached.
Standard: - Conforms to the specifications of:ASTM D93; IP 34; ISO 2719
Features & Benefits:-
1)     Temp. Range: 40 to 400° deg C.
2)     Test Method: ISO 2719, ASTM D 93, IP 34, IS 1448 (P-21).
3)     Ignition Source: Electrical ignitor with LPG gas connection.
4)     Temperature Sensor: PT-100 in stainless steel sheath.
5)     Flash Detector: CRC Thermocouple.
6)     Controller: Touch Screen, Colour Display with PLC with audio visual alarm to check the machine. 3-wire RTD temperature sensor, free potential flame detector sensor as i/p. with automatic barometric reading correction.
7)     Inbuilt storage memory for Flash Detection.
8)     Flame-Sampling Arrangement: 10 Rpm, D.C. 12 v or 24V DC, gear motor, vertical movement reciprocating to & fro motion.
9)     Heater: 800 W, 230v.
10)  Electrical ignition flame-sampling. Ignition transformer having continuous o/p of 10.6 Kv. D.C. from 230 v A.C. i/p.
11)  Equipment Overall Size (LxWxH): 280mm (W) X 530mm ( D ) X 415 mm ( H )
12)  Equipment Gross Weight: 22 Kg.
13)  Equipment supply will be 230 V Ac, 50 Hz with 15 amp capacity.
Features:-Single Action Setting: - The Flash Detection sensor and temperature sensor are permanently mounted on a lid, which allows easy setting of the specimen.Easy Operation: - Select a Test Mode and enter the expected flash Point. While instrument executes the test, you are free to do other lab work. The tester follows the exact procedures prescribed in the test method and the completion of the test cycle is signalled by buzzer. The test result is brightly shown in VFD and same will be stored in the HMI.
Automatically Shut The Machine And Horn The Buzzer In The Case:

Accessories Will Be Supplied With Equipment:-
1)     Pensky Martene  Cup & Lid  --  1 No (Cat No Hamco30ac1)
2)      Thermal Printer  -- 1 No (Cat No Hamco30ac7)
3)     Thermal Printer Roll  --  1 No (Cat No Hamco30ac8)
4)     Pc Interface Cable – 1 No. (Cat No Hamco30ac9)
5)     Software For Above-- 1 No. (Cat No Hamco30ac10)
6)     Thermal Fuse – 1 No. (Cat No Hamco30ac5)
7)     Signal Cable - 1 No. ( Cat No Hamco 30ac6)
Ordering Information:-